Daily maintenance
Check the level and concentration of lubricating oil and cutting fluid
Drain the accumulated water from the air source filter and confirm that the air pressure is normal
Check for wear and damage to the handle and cutting tools
Check the body for oil leakage, water leakage, and abnormal noise
Weekly Maintenance
Wipe and clean the guide rail, and replenish lubricating grease
Disassemble and clean the water tank filter, clean the debris in the chip conveyor
Clean the heat dissipation filter of the electrical control cabinet to avoid high temperature alarms
Clean the knife magazine and claws, check the smoothness of tool replacement
End of month maintenance
Fully lubricate the three-axis screw and check the integrity of the dust cover
Inspect the oil, gas, and water pipelines for leaks and aging
Recheck the level of the machine tool and tighten the foundation bolts
Detect the operating status of solenoid valves and limit switches
Annual major maintenance
Spindle accuracy testing and bearing condition inspection
Three axis clearance detection and precision compensation calibration
Replace hydraulic oil, lubricating oil, and complete set of seals
Tightening of electronic control circuits and inspection of overall safety circuits
